AWG G3 PAD FOR PS3 Especificaciones descargar pdf (Pagina 84)

4 Test Head Filling and DUT Board Considerations Test System Configuration

84 System Reference, January 2001

Figure 41 Fill Order of Analog Instruments within the Analog Dominant

Configuration

In Figure 41the eight lightly shaded (yellow) boxes are

the half groups of the four groups which can support

analog instrument within the 1024 pin analog dominant

configuration. Thus, for this configuration the analog

instruments can only be placed in those card cages corre-

sponding to groups 2, 6, 7 and 8. In the case of the 512 pin

digital dominant configuration, the analog instruments

can only go in the card cage slots corresponding to groups

2 and 8.

The analog time analysing or measuring instruments go

in the half groups titled MEAS. The analog signal genera-

tors go in the half groups titled SOURCE. Depending on

the half group, the abbreviations of analog instruments

correspond to either source or measurement in the table

in Table 5. The numbers next to an abbreviation assign

the counting number of an instrument type. These count

numbers increase with increasing filling of the cages. The

fill order of the cages is marked above the brackets on top

of the group sketches. The slot number of the slots where

an analog module has to go within the cage is mentioned

on the left of the half groups.

A TIA test head card always comes with a GP TIA and

either with a second GP TIA or optionally with a HP-TIA.

The first card containing a GP TIA is placed in slot 1 of

group 8 as the second one goes in the first slot of group 6.

In each of the two slots you can chose one of the two

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 284 285

Sin comentarios

AWG G3 PAD FOR PS3 Especificaciones Pagina 84