AWG 64 MB MEMORY CARD FOR WII Manual de usuario descargar pdf (Pagina 26)

USER MANUAL 1.4 | EC1000

Berghof Automation GmbH | Harretstrasse 1 | 72800 Eningen | www.berghof.com

EC1000_HB_en_2D1652005ZD00.docx | 2VF100180FE02.docx

Power LED

4 operating status LED indicate the current status of the voltage supply, module mode and error messages.

LED

Logical status

PWR (green)

ON = correct voltage supply to the module electronics

RUN/STOP BUTTON

The Run/Stop control button replaces the former control switch.

This slightly changes the operating concept:

Action

Command

Submarine, boot phase

Activation of the pushbutton

Change into PPP mode or submarine

console

CODESYS PLC/ CP1131-P

Short push

Change between RUN and STOP mode

of PLC

Long push

STOP the PLC using RESET of the vari-

ables, but not the retain data (correspon-

ding to the activation of the rocker switch

on the DC1000 modules)

It is then no longer possible to force-hold the PLC controller in the STOP state!

LEDs: RUN/STOP ERROR - LED signalisation

2 LED are available on the module to signalise the system status (RUN/STOP in two colours:

red/green/(yellow); ERROR in red only). The flash codes familiar from the DC1000 are therefore no longer

applicable. The following system states are signalised via the LED:

System states

LED RUN/STOP

LED ERROR

PPP configuration mode active

Yellow

Off

USB packet update active

Yellow, flashing

Off

System error

Off

PLC states

RUN

Green

Off

STOP

Red

Off

Error stop

Red

Reset button registered

Red, flashing

Off

Applicatory states

Identification of ProfiNET device

Yellow, flashing

Flash

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Comentarios a estos manuales

Sin comentarios

AWG 64 MB MEMORY CARD FOR WII Manual de usuario Pagina 26

Comentarios a estos manuales